Remember me
Lost Password Register


Steel 120 with small neck threads
02-16-2010, 06:15 PM,
#1
Steel 120 with small neck threads
Hi guys-

I just bought a used steel 120 in great shape, EXCEPT (of course there's an except!) the valve knob just spun completely around. Turns out the previous owner must have broke the handle, then drilled it out and shoved a screw in it. It is a Genysis DIN valve and though I might be able to fix it- I'd much rather just replace it for safety.

Here's the catch- the tank has a seat at the neck and the threads are smaller diameter than a standard valve. I was thinking maybe an old 1/2", but did they have Genysis DIN valves in that "era"? The really frustrating thing is that I just switched everything over to DIN H-Valves and now I don't know what to do with this tank if it can't follow suit.  Any suggestions?
Reply
02-16-2010, 07:58 PM, (This post was last modified: 02-16-2010, 07:59 PM by matt t..)
#2
Re: Steel 120 with small neck threads
You have an older HP 120 with the 7/8 neck thread. You may just need a new $10 rubber knob. The valves themselves aren't as common as they used to be, but certainly shouldn't be hard to find. Any dive shop should have a couple laying around.
Reply
02-19-2010, 06:48 PM,
#3
Re: Steel 120 with small neck threads
Ebay is offering them out of Wisconsin. They are going out of production as most all cylinder mfgs are going to 3442 psi to offer the convertible 200bar/DIN combo.

Lee
Reply




Users browsing this thread: 2 Guest(s)