|
Getting Started
|
|
08-08-2005, 10:00 AM,
|
|||
|
|||
|
Re: Getting Started
you might also want to look at Fred T. backplates (he's on most major national forums) He makes them himself. They are very adaptable, with 3 sets of bolt holes to make adjusting your trim very easy by simply moving the whole set of doubles (or single in your case) up or down one setting. Very handy.
It costs about the same as most of the others. |
|||
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Getting Started - by voodooconstant - 08-07-2005, 12:33 AM
Re: Getting Started - by Swimjim - 08-07-2005, 04:43 AM
Re: Getting Started - by schultz - 08-07-2005, 06:20 AM
Re: Getting Started - by voodooconstant - 08-07-2005, 05:24 PM
Re: Getting Started - by Omicron - 08-07-2005, 06:43 PM
Re: Getting Started - by jasondbaker - 08-07-2005, 06:47 PM
Re: Getting Started - by voodooconstant - 08-07-2005, 06:54 PM
Re: Getting Started - by Chris H - 08-07-2005, 08:09 PM
Re: Getting Started - by schultz - 08-07-2005, 08:59 PM
Re: Getting Started - by voodooconstant - 08-08-2005, 08:09 AM
Re: Getting Started - by Omicron - 08-08-2005, 08:13 AM
Re: Getting Started - by Chris H - 08-08-2005, 08:21 AM
Re: Getting Started - by fishchaser - 08-08-2005, 09:16 AM
Re: Getting Started - by scubert - 08-08-2005, 10:00 AM
Re: Getting Started - by voodooconstant - 08-08-2005, 10:01 AM
Re: Getting Started - by FreediveWI - 08-08-2005, 12:24 PM
Re: Getting Started - by voodooconstant - 08-08-2005, 03:25 PM
|
Users browsing this thread: 2 Guest(s)